Passing Parameters To WebDev

Hi All

I am opening a WebDev dynamic page from outside of any WebDeb project. It is itself a one page project. It takes one parameter.

PROCEDURE MyPage(MyInt is int) I have also tried MyInt is int

Calling the page as follows : [123.456.789.123]

A fellow WebDev developer has a similar scenario so I just used his syntax.

When opening the page I get an error message "1 parameters were expected while 0 parameters have been passed"

What am I doing wrong?

Cheers
Andre

Stupid links.

The URL is as follows: "[myip]; I hopt this html editor does not unilaterally change that now.

It did.

I will try again.

Starts with http://

Then the ip address/domain

Then the page

Then the parameter to pass ?MyParameter=1

Sorted.