[WD26] Exe Creation ends with ERROR 110

Hi,

I tried to create a *.exe with all dll´s embedded. It ends with "error 110" (a file could not opened)
Unfortunately nothing else in the error message.

UAC is off, virus scanner is off. I have had this issue times ago, but I don´t remember how to fix it.

The exe creation without embedding the dll´s works.

Any ideas ?

regards Michael

Looks like one of the dll is missing and can"t be included...

So, in the exe creation process, look at the plane where the dll used are listed and check them all on disk one by one. You should find the one missing (perhaps quarantined previsouly by your A/V)... At that point, you need to find it somewhere and put it back (or stop using it in the program, if at all possible)

Hi Argus,

[x] checked. No one is missing ...

regards Michael