Hello All,
I have a table control I load with tableAddline.
I recently added a break on 1 of the columns and 3 controls, 1 button 2 static controls, in the break header.
On the simulator everything works fine but when I run it on the device the controls are not there.
I have no code on the controls at all and the header is set to visible along with the controls. No anchors either.
I have wasted 4 hrs trying everything under the sun and I do not see anything n the help that says this should not work.
DW
Edited 1 time(s). Last edit at 09/09/2018 08:20PM by cabinetman.